RIGHT TO BEAR 4.5" STRAIGHT PROFILE BARREL 9MM + FREE DIMPLED FLASH CAN | 1/2X36

This 9mm 4.5 inch Straight Profile Barrel is machined from 4150 Chrome Moly Vanadium steel with a QPQ Corrosion Resistant Finish.

This 4.5” barrel is a fully machined barrel precision-crafted from 4150 Chrome Moly Vanadium, rifled with a 1:10 twist and QPQ coated inside and out. The result is an accurate barrel that stays that way without chipping or peeling coatings and little risk of damage from corrosion, regardless of your operating environment.


**Disclaimer** These barrels have no Index pin or dedicated feed ramps

Caliber 9mm
Length 4.5
Material 4150 Chrome Moly Vanadium
Profile Straight
Finish QPQ Corrosion Resistant
Gas System Length None
Gas Block Journal N/A
Dimpled? No
Twist Rate 1:10
Muzzle Thread 1/2x36 TPI
Weight 8.3oz
Barrel Extension Integrated
Target Crown 11 Degree
Muzzle Device Info:

This adds a unique look compared to the average Flash Hider or Muzzle Break. Keep in mind that it does not use a crush washer so it should be torqued directly against the barrel shoulder. Its specs are as follows:
All NFA/ATF Rules Apply
 
Depending on your state and local laws, you could use this barrel with a lower receiver that is a Registered SBR, or Pistol. Possession of this barrel along with a Non-NFA lower receiver may be Prohibited. We are not lawyers and the above information is not legal advise. Make sure you understand the most up to date federal, state and local laws before proceeding with this product.